Documents

How to configure remote management on Omada Gateway

Remote Management lets you manage the router remotely when you are not on the router's local network. It provides convenience for network management.

OC200(UN)_V3_3.1.1 Build 20260227

How to Configure Basic Counting Mode for People Counting on Omada Central

This article provides instructions on how to configure Basic Counting Mode for the People Counting feature on Omada Central. Basic Counting Mode counts walk-ins and walk-outs only, without analyzing pass-by traffic. It is suitable for small and medium-sized retail scenarios where the camera coverage is limited to the store entrance and does not extend to external areas.

Omada Cloud-Based Controller_V6.1_Datasheet

Omada Software Controller_V6.1_Datasheet

Controller v6.2 VPN Overview

How to manage Flex Bridge 5 on Omada Controller

How to build a Wireless Network between the home and farm using Omada devices

EAP683 UR(EU)_V1_1.3.1 Build 20250804

Flex Bridge 5(EU)_V1_1.0.0 Build 20260207

Why Can I Configure Fewer VLANs Than Expected on My Agile Switch

When using Omada Agile Switch (ES Series) together with Omada Controller, you may notice that the available number of VLANs is not the expected 32, but 31 instead. This document explains the reason for this phenomenon and the specific scenarios in which it may occur.

EAP725-Outdoor(EU)_V1_1.0.7 Build 20260112

OC200(UN)_V3_Datasheet

SM5220-3M(UN)_V2_Datasheet

SM5220-1M(UN)_V2_Datasheet

How to Use the Recovery Mode to Recover the Firmware for Omada Campus Switches

During a firmware upgrade, there are three essential parts: uboot, kernel and usrlmg, the phenomenon are different if the different parts are damaged. In this article, we will briefly introduce the possible errors user may encounter during boot up and the procedure of recovering damaged firmware if unable to boot normally on Omada Campus switches, please check each section follow the corresponding guide to recover according to the error you are seeing on the device.

How to Use the Speed Test Feature on the Omada Controller v6.2 and above

Starting from v6.2, Omada Network System introduces the Speed Test feature, offering both manual and scheduled modes to help us monitor network quality easily.

EAP650GP-Desktop(EU)_V1_1.0.2 Build 20251103

Flex Bridge 5_V1_Regulatory Compliance

How to config LLDP on Omada Gateway via Omada Controller

LLDP (Link Layer Discovery Protocol) is a standardized Layer 2 protocol that enables network devices to automatically discover and share information about their directly connected neighbors. By exchanging details such as device identity, port information, system capabilities, and management addresses, LLDP helps network administrators map network topologies, troubleshoot connectivity issues, and facilitate automated configurations.