Documents

Introduction About CLI on Omada AP (For Controller V6.1 and Above)

How to Configure Port Mirroring on Omada Switches

Port mirroring copies network traffic from one or more source ports to a destination (monitor) port, allowing network administrators to analyze traffic for security, performance monitoring, and troubleshooting without disrupting the live network.

How to Configure Port Isolation on Omada Switches

Port Isolation lets you block traffic between specific ports so you can protect your network and control how devices communicate. In standalone mode, you can set flexible isolation rules; however, in controller mode, the feature is simplified for compatibility—when you enable it on a port, that port becomes isolated and cannot communicate with any other isolated port.

How to configure Port Security on Omada Switches

Port Security allows you to set a limit on the number of MAC addresses that can be learned on a switch port, preventing MAC table exhaustion caused by malicious flooding attacks and ensuring stable network performance. When the number of learned MAC addresses exceeds the configured threshold, the switch can block unauthorized addresses, restrict abnormal traffic, or send alerts to administrators for timely response.

OC200(UN)_Multi-model_Installation Guide

SG2005P-PD(UN)_V2_Installation Guide

How to Design and Deploy Your Network with Omada Design Hub

Omada Design Hub offers a convenient and visualized platform to easily plan your network and select the most suitable network products to deploy. AI tools are also available to facilitate your planning process.

OC200(UN)_V3_Regulatory Compliance

TL-SG3428MP(UN)_V5_5.0.25 Build 20260113

TL-SG3452P(UN)_V3_3.0.22 Build 20260121

SG2210XMP-M2(UN)_V1_1.0.19 Build 20260121

SG2452LP(UN)_V1_1.0.13 Build 20260121

EAP615GP-Wall(EU)_V1_1.1.1 Build 20251224

EAP625GP-Wall(EU)_V1_1.1.1 Build 20251224

EAP603GP-Desktop(EU)_V1_1.1.1 Build 20251224

What is Management Port on Omada Campus Switch and How to Use It

The configuration of management port could only be conducted through CLI, you could either access via SSH/Telnet or the console port. By default, the management interface will obtain IP address through DHCP, which means if you do not connect the management port to a valid DHCP server, it won’t get a valid IP address for you to access. You could also configure a static IP address for the management interface.

SG3210XHP-M2(UN)_V3_3.0.21 Build 20260121

SX3832(UN)_V1_1.0.12 Build 20260121

SG3210X-M2(UN)_V1_1.0.19 Build 20260121

SG2210MP(UN)_V5_5.0.15 Build 20260121