AX1800 Indoor/Outdoor Wi-Fi 6 Access Point

How to assign a static IP address to the EAP using Omada APP

Learn how to configure a static IP address for your EAP (Omada Access Point) using the Omada APP.

How to separate a large amount of VLAN via Bridge VLAN and SSID VLAN (with VLAN Pool)

Bridge VLAN is a feature that allows multiple VLANs to share a single Layer 3 interface and DHCP pool to reduce gateway resource usage. SSID VLAN binds a specific SSID to one or multiple VLANs for straightforward traffic isolation. By combining Bridge VLAN and SSID VLAN, you can meet the requirements of the apartment or hotel room network design without creating a large number of Layer 3 interfaces.

How to find IP address of my Omada Devices

By default, Omada devices use dynamic IP addresses. Whether connected to the internet or not, devices such as EAPs or switches should automatically obtain an IP address as long as they are connected to a local network or a DHCP server. There are different ways to find the IP address of an Omada device. Whether the device is in standalone mode or controller mode, you can also use the Omada APP or Discover Utility to find it.

How to create a VLAN using Omada App

Creating a VLAN using Omada App just needs a few steps, in this article, you will learn how to set it up.

EAP623-OutdoorHD(EU)_V1_1.4.4 Build 20250718

How to detect Rogue Access Points on Omada Controller

How to upgrade EAP firmware in different management modes

EAP623-Outdoor HD(EU)_V1_1.4.3 Build 20250520

EAP623-Outdoor HD(EU)_V1_Build 20250318

How to Configure Installation Type for Omada Outdoor AP

Regulations on indoor/outdoor wireless use vary by region, impacting Omada Outdoor AP performance and compliance. If deployed incorrectly, certain 5GHz channels may be restricted. For example, in Germany, CE regulations prohibit outdoor use of UNII-1 and UNII-2A bands, while all UNII-1 to UNII-2C bands are allowed indoors. To ensure compliance and optimal performance, Omada Outdoor APs support Installation Type, allowing users to adjust settings based on deployment scenarios.