Access Point Wall-Plate Wi-Fi 6 AX3000

How to assign a static IP address to the EAP using Omada APP

Learn how to configure a static IP address for your EAP (Omada Access Point) using the Omada APP.

How to separate a large amount of VLAN via Bridge VLAN and SSID VLAN (with VLAN Pool)

Bridge VLAN is a feature that allows multiple VLANs to share a single Layer 3 interface and DHCP pool to reduce gateway resource usage. SSID VLAN binds a specific SSID to one or multiple VLANs for straightforward traffic isolation. By combining Bridge VLAN and SSID VLAN, you can meet the requirements of the apartment or hotel room network design without creating a large number of Layer 3 interfaces.

How to find IP address of my Omada Devices

By default, Omada devices use dynamic IP addresses. Whether connected to the internet or not, devices such as EAPs or switches should automatically obtain an IP address as long as they are connected to a local network or a DHCP server. There are different ways to find the IP address of an Omada device. Whether the device is in standalone mode or controller mode, you can also use the Omada APP or Discover Utility to find it.

How to create a VLAN using Omada App

Creating a VLAN using Omada App just needs a few steps, in this article, you will learn how to set it up.

How to Capture Wireless Packets via EAP and Omada Controller

Wireless Packet Capture are very important diagnostic tool to analyze wireless communication between an Access Point (AP) and clients, and troubleshoot issues such as wireless packets loss, weak signal, and roaming failures., etc. Omada APs compatible with Omada Controller v6.0 and above support Over-the-Air (OTA) Capture and Non-Over-the-Air (Normal) Capture. This article will provide a step-by-step guide on how to capture wireless packets by using Omada Software Controller v6.0 and EAP787.

How to detect Rogue Access Points on Omada Controller

How to upgrade EAP firmware in different management modes

EAP655-Wall(EU)_V1_1.4.2 Build 20250319

Getting started with the standalone EAP

This article introduces how to quickly set up the Omada EAP in Standalone mode.

EAP655-Wall(EU)_V1_1.3.1 Build 20240929