EAP225(US)_V3_2.4.0 Build 20181121

Recommended Controller Software Version:  Omada Controller v3.0.x or above

New Features/Improvements:

1. Add Band Steering/LED Locate/Client rate limit/SSID rate limit Function in Standalone mode.

2. The SSID isolation function is promoted to the Guest Network Function. Wireless Clients connected with Guest SSID can’t communicate with each other and the local network.

3. UI optimization.

4. Add “More Client Detail Log” function at Management->Log Settings->Enable Server to output more client information, such as client MAC address, SSID and AP MAC address.

5. Change the HTTP port of Portal authentication page from 80 to 22080 in standalone mode.

 Bug Fixed:

1. Fixed the bug that HTTPS redirection of Portal authentication page will be inoperative when the IP address of Omada EAP and wireless clients belong to different subnet.

2. Fixed the bug that HTTPS redirection of Portal authentication page will be inoperative when Omada Controller and Omada EAP belong to different subnet.

3. Fixed the bug that when we change the IP in standalone mode, the portal authentication page may not pop up successfully.

4. Fixed the bug that the wireless clients may not be redirected to portal authentication page by surfing HTTPS website if we enable Management VLAN function.

5. Fixed the bug that wireless clients connected with 2.4G SSID of EAP may receive broadcast packets from other VLAN.

6. The rate limit of Portal function may not take effect sometimes.

Notes:

1. For EAP225_v3 only.

2. Your device's configuration won't be lost after upgrading.