EAP225(US)_V3_2.6.0 Build 20190726

Recommended Controller Software Version: Omada Controller v3.2.x or above

New Feature/Enhancement:

1. Change the OpenSSL version to 1.0.2q.

2. Optimize UI, including character optimization and display error correction.

3. Update the time zone of Caracas from GMT-4:30 to GMT-4:00.

Bug Fixed:

1. Fixed the bug that client devices can pass the portal authentication after disconnected from the Controller.

2. Fixed the bug that untag packets can be transferred to SSIDs with different VLANs.

3. Fixed the bug that mesh AP may disconnect from the Controller after long-time running.

4. Fixed the bug that fast roaming may not take effect in some mesh network.

5. Fixed the bug that some EAPs may disconnect from the Omada Controller in large scale network.

6. Fixed the bug that the management page may not be accessed after EAP is disconnected from the Controller.

7. Fixed the bug that when APs are disconnected from Controller, the rate limit configuration will be not issued to these APs after they are back to connected again.

8. Fixed the bug that when the time of EAP is synchronized with PC, it will be the same as PC’s time not considering different time zones.

9. Fixed the bug that packets with VLAN tag can be forwarded to the SSID without wireless VLAN setting.

Notes:

1. For EAP225 v3 only.

2. Your device's configuration won't be lost after upgrading.

3. This version of firmware is applied to Omada APP of version 2.1.X or above.