How to Configure a Guest Network on an Omada Controller

Knowledgebase
Configuration Guide
Controller
08-13-2024
237

Contents

Objective

Requirements

Introduction

Configuration

Verification

Conclusion

 

Objective

This article outlines how to configure the Guest Network feature on an Omada controller.

 

Requirements

  • Omada Controller (Software Controller / Hardware Controller / CBC, v5.9 and above)
  • Omada AP

 

Introduction

The Guest Network feature allows you to set up a network that is independent of the main network. You can configure a separate SSID and password for the guest network, allowing guests to access the internet while remaining isolated from the main network. Clients connected to the guest network can access the internet but cannot access or download the internal network resources, thereby safeguarding the privacy and network security of the main network

 

Configuration

Step 1. Go to Setting > Wireless Network > WLAN and click Create New Wireless Network to load the following page.

Step 2. Customize the Network Name (SSID), select a Security mode (WPA-Personal is used as an example), enter the Security Key, check the box to enable Guest Network, and click Apply to save the settings.

 

Verification

Once configured, you can use two clients to verify that the function works.

Step 1. Connect two clients to the SSID, for example, a desktop computer (IP: 192.168.0.102) and a mobile phone (192.168.0.101).

Step 2. On the desktop computer, ping the mobile phone’s IP. The ping fails, but the computer and the phone can access the internet, indicating that the function has been enabled and works properly.

 

Conclusion

Guests can access the internet through the guest network.

 

 

Please Rate this Document

Related Documents