How to set up rate limit through EAP controller

1. Click on the upper right corner of the management interface. Go to Wireless Settings > Basic Wireless Setting to load the following page.

2. Click to configure the corresponding SSID, and click Rate Limit to load the following page.

3. In the Rate Limit section, enable Rate Limit and specify the download limit and upload limit. Click Apply.

Note: Before configuring Rate Limit Based on Clients, make sure that there are clients connected to the controller.

1. Go to Clients and click to configure the corresponding client. Then click Rate Limit to load the following page.

2. Specify the download limit and upload limit. Click Apply.

Note: Before configuring Rate Limit Based on Voucher/Local User, configure Voucher/Local User Portal first.

For Voucher

1. Click on the upper right corner of the management interface. Go to Wireless Control > Portal to load the following page.

2. Click to configure the corresponding Voucher Portal. Click Voucher Manager to manage the vouchers.

3. On the Management page, go to Voucher and click to create vouchers and specify the download limit and upload limit. Click Apply.

For Local User

1. Click on the upper right corner of the management interface. Go to Wireless Control > Portal to load the following page.

2. Click to configure the corresponding Local User Portal. Click User Management to manage the users.

3. On the Management page, go to User and click to create local users and specify the download limit and upload limit. Click Apply.