EAP225-Outdoor(EU)_V1_1.4.1 Build 20181107

Recommended Controller Software Version: Omada Controller v3.0.x or above

New Feature/Enhancement:

1. Add Band Steering/LED Locate/Client rate limit/SSID rate limit Function in Standalone mode.

2. The SSID isolation function is promoted to the Guest Network Function. Wireless Clients connected with Guest SSID can’t communicate with each other and the local network.

3. UI optimization.

4. Change the HTTP port of Portal authentication page from 80 to 22080 in standalone mode.

5. Omada EAP still broadcast SSID after entering the isolated state in the factory state.

6. Add “More Client Detail Log” function at Management->Log Settings->Enable Server to output more client information, such as client MAC address, SSID and AP MAC address.

Bug Fixed:

1. Fixed the bug that the channel of EAP (with Channel limit function enabled) may switch to ch36 (Band1) from Band3 when the EAP detect a radar signal.

2. Fixed the bug that when we change the IP in standalone mode, the portal authentication page may not pop up successfully.

3. Fixed the bug that the wireless clients may not be redirected to portal authentication page by surfing HTTPS website if we enable Management VLAN function.

4. Fixed the bug that HTTPS redirection of Portal authentication page will be inoperative when the IP address of Omada EAP and wireless clients belong to different subnet.

5. Fixed the bug that the rate limit of portal may not take effect sometimes.

Notes:

1. For EAP225-Outdoor (EU) v1 only.

2. Your device's configuration won't be lost after upgrading.