Documents

Getting started with an Omada Fusion Gateway

This article will guide you through getting started with your Omada Fusion Gateway.

How to Configure Load Balancing on Omada Gateways

How to Use Remote Access on Omada Controller

How to configure remote management on Omada Gateway

Remote Management lets you manage the router remotely when you are not on the router's local network. It provides convenience for network management.

How to Configure Basic Counting Mode for People Counting on Omada Central

This article provides instructions on how to configure Basic Counting Mode for the People Counting feature on Omada Central. Basic Counting Mode counts walk-ins and walk-outs only, without analyzing pass-by traffic. It is suitable for small and medium-sized retail scenarios where the camera coverage is limited to the store entrance and does not extend to external areas.

Controller v6.2 VPN Overview

How to manage Flex Bridge 5 on Omada Controller

How to build a Wireless Network between the home and farm using Omada devices

Why Can I Configure Fewer VLANs Than Expected on My Agile Switch

When using Omada Agile Switch (ES Series) together with Omada Controller, you may notice that the available number of VLANs is not the expected 32, but 31 instead. This document explains the reason for this phenomenon and the specific scenarios in which it may occur.

EAP670_V2.20_Datasheet

EAP615GP-Wall_V1_Datasheet

EAP725-Outdoor(US)_V1.6_Datasheet

EAP725-Outdoor_V1_Datasheet

EAP668-Outdoor HD(US)_V1.6_Datasheet

EAP668-Outdoor HD(US)_V1_Datasheet

SG3452XMPP_V1.6_Datasheet

SG3452XMPP_V1_Datasheet

EAP772_V1_Datasheet

EAP772_V2_Datasheet

How to Use the Recovery Mode to Recover the Firmware for Omada Campus Switches

During a firmware upgrade, there are three essential parts: uboot, kernel and usrlmg, the phenomenon are different if the different parts are damaged. In this article, we will briefly introduce the possible errors user may encounter during boot up and the procedure of recovering damaged firmware if unable to boot normally on Omada Campus switches, please check each section follow the corresponding guide to recover according to the error you are seeing on the device.