How to implement an external DHCP server with DHCP Relay in the Omada Ecosystem with Omada Switches

In some network environments within the Omada Ecosystem, a third-party (external) DHCP server may be required instead of using the gateway’s built-in DHCP service. This guide explains how to configure Omada Switches to ensure that client devices can correctly reach and obtain IP addresses from the designated DHCP server after connecting to the network via DHCP Relay.

SG6654X(UN)_V1.20_1.20.5 Build 20260205

How to Use the Recovery Mode to Recover the Firmware for Omada Campus Switches

During a firmware upgrade, there are three essential parts: uboot, kernel and usrlmg, the phenomenon are different if the different parts are damaged. In this article, we will briefly introduce the possible errors user may encounter during boot up and the procedure of recovering damaged firmware if unable to boot normally on Omada Campus switches, please check each section follow the corresponding guide to recover according to the error you are seeing on the device.

What is Management Port on Omada Campus Switch and How to Use It

The configuration of management port could only be conducted through CLI, you could either access via SSH/Telnet or the console port. By default, the management interface will obtain IP address through DHCP, which means if you do not connect the management port to a valid DHCP server, it won’t get a valid IP address for you to access. You could also configure a static IP address for the management interface.

SG6654X(UN)_V1.20_1.20.4 Build 20251208

What is VRF and How to Configure VRF on Omada Campus Switches When Adopted by Omada Controller

How to configure Switch QoS in Controller Mode

Omada switch QoS enables prioritized traffic handling via DSCP mapping and SP/WRR scheduling, ensuring optimal performance for critical services like voice and video.

How to Maintain Management VLAN and Port Settings When Adopting Switches on Omada Network V6

Before Omada Controller V6, when adopting a switch on controller, the default configuration will be applied to the switch and override all the previous pre-configuration done in standalone mode. This could cause inconvenience while adopting switches to a network which management VLAN is not the default VLAN. If the default configuration, especially the default VLAN interface, overrides the pre-configuration done on the switch, it will be disconnected after adoption and hard to recover.

SG6654X(UN)_V1.20_1.20.3 Build 20251031

How to configure Management VLAN for Omada Devices (Omada Controller 5.15 or above)

The management VLAN is a VLAN created to separate the management network from the data network. By default, the management VLAN is the LAN network in a network centrally managed by Omada SDN Controller. You can change the management VLAN to improve network security. With a separated management VLAN, it is much harder for unauthorized users to modify the configurations or monitor the network.