文件

如何透過Bridge VLAN 和 SSID VLAN（搭配 VLAN Pool）來區分大量的 VLAN

Bridge VLAN is a feature that allows multiple VLANs to share a single Layer 3 interface and DHCP pool to reduce gateway resource usage. SSID VLAN binds a specific SSID to one or multiple VLANs for straightforward traffic isolation. By combining Bridge VLAN and SSID VLAN, you can meet the requirements of the apartment or hotel room network design without creating a large number of Layer 3 interfaces.

How to find IP address of my Omada Devices

By default, Omada devices use dynamic IP addresses. Whether connected to the internet or not, devices such as EAPs or switches should automatically obtain an IP address as long as they are connected to a local network or a DHCP server. There are different ways to find the IP address of an Omada device. Whether the device is in standalone mode or controller mode, you can also use the Omada APP or Discover Utility to find it.

How to configure Link Aggregation for EAP

Learn how to configure Link Aggregation on EAP with this step-by-step guide. Enhance your network performance and redundancy effectively.

How to create a VLAN using Omada App

Creating a VLAN using Omada App just needs a few steps, in this article, you will learn how to set it up.

Getting Started with an Omada Pro Controller

如何透過控制器擷取EAP的無線封包

Wireless Packet Capture are very important diagnostic tool to analyze wireless communication between an Access Point (AP) and clients, and troubleshoot issues such as wireless packets loss, weak signal, and roaming failures., etc. Omada APs compatible with Omada Controller v6.0 and above support Over-the-Air (OTA) Capture and Non-Over-the-Air (Normal) Capture. This article will provide a step-by-step guide on how to capture wireless packets by using Omada Software Controller v6.0 and EAP787.

如何在交換器上設定sFlow

如何在獨立模式下設定 Omada 交換器的 QoS

如何在 Omada 控制器設定 Webhook

如何在 Omada 路由器上設定 Google LDAP

如何設定 Omada 路由器的 DNS override

How to upgrade firmware of Omada Gateway in controller mode

How to filter events in Omada Central when watching playback

如何在 Omada 控制器上偵測非法AP

How to upgrade EAP firmware in different management modes

How to Configure M-LAG on Omada Switches

Omada 交換器如何支援 PTP？

How to configure Dying Gasp on Omada Campus switches

How to configure MAC-Delay on Omada S6500 and S7500 series switches

How to Configure MAD on Omada S6500 and S7500 series Switches