ER605(UN)_V1_1.1.1_20210723

This firmware is fully adapted to Omada SDN Controller 4.3.5 or above.

It is recommended to reboot ER605 before upgrading the firmware, as some of the below bugs in an older version of the firmware may cause the upgrade to fail.

New Feature/Enhancement:

1. Add Emergency mode to recovery the firmware, please refer to FAQ3062.

2. Add support for IPv6.

3. Add support for Daylight Saving Time (DST).

4. Optimize the priority of One-to-One NAT and IPsec tunnels.

5. New features in controller mode:

5.1 PPTP/L2TP VPN can be selected as the Interface for static route and policy routing.

5.2 Add support to customize the firewall parameters.

5.3 Routing table, VPN, DDNS and Port forwarding status can be displayed on the Insight page.

5.4 Optimize the export of OpenVPN certificate.

6. New features in standalone mode:

6.1 Multi networks are supported.

6.2 LAN-to-LAN ACL are added to manage the behavior between networks, refer to FAQ3061 for Configuration Guide.

Bug Fixed:

1. Fix the bug that Omada Gateway cannot be adopted after upgrading the firmware.

2. Fix the bug that the device account was reset after multiple configurations.

3. Fix the bug that TTL of the packets is reduced by 2 after forwarding.

4. Fix the bug that the existing sessions may not be switched to the backup WAN when performing the link backup.

5. Decouple some configurations of WAN and LAN.

6. Fix the bug that Virtual Server, One-to-One NAT, and NAT Loopback failed.

7. Fix the bug that Speed Test failed in some circumstances.

Notes:

1. For ER605 (TL-R605) v1.0 and v1.6.

2. Your device’s configuration won’t be lost after upgrading.

3. This firmware is applied to the Omada APP of version 3.0.x or above.